Stainless for 15mm PEX piping. For clamping ring connections, nipples, T-connectors, bends and ball-valves of 15 mm dimensions.NOTE! Install the pipe in the wall in such a way that there is no movement between the pipe and the wall panel (or similar) when the waterproofing layer is installed.#Pull out the piping 50-100 mm from the wall. Make a nogging piece between 2 joists. # Once the wall covering is in position the piping is pressed against the inner wall for measurement. Cut 17 mm from the wall. Sand off any burring after the cutting. # Mount the sealing membrane on the piping. # Screw home the wall washer to the wall (with the drainage hole downwards). Seal the screw threads with silicone. The wall washer is fitted with a seal against the piping and between nipple and steel plating. # Slip the clamp ring on the piping. # Push in the support socket nipple in the piping. # Fit the connector to its stop point. Re-tighten one and a half revolutions until a lock is achieved, take a steady grip in the connector (Bend, T-connector, connector pipe) where the screw nut should be so mounted as to avoid damage to the screw threads.
More about cookies.
Dear customer. You are using an old and outdated browser. Please upgrade in order to get best possible experience.